New Reef Fish Gear Rules
State and federal regulations require all commercial fishers and recreational anglers fishing for any reef fish species in the Gulf of Mexico to use circle hooks, dehooking devices and venting tools. These rules became effective on June 1, 2008 in all waters of the Gulf of Mexico and affect all reef fish species including groupers, snappers, amberjacks, triggerfish, porgies, sea bass, hogfish, and tilefish. As of July 29, 2009, new regulations require recreational and commercial fishers to use dehooking devices when fishing for reef fish in federal waters of the Atlantic off Florida. The FWC proposed a draft rule requiring dehooking devices in state waters of the Atlantic at its September meeting in Howey-in-the-Hills.
The intent of these new rules is to help conserve fishery resources by minimizing mortality associated with releasing fish that are not going to be harvested due to regulations or for other reasons. Fishers and anglers are being asked to be responsible to acquire and use the required gear when fishing for reef fish species. Additionally, common sense should be used in abiding by these rules. For instance, if a hook is too far embedded in the throat or gut of the fish, it is much better to cut the line from the hook rather than try to remove the hook with a dehooking device. The non-stainless steel hooks will disintegrate in a relatively short period of time and should cause the fish less harm. Also, fish should only be vented after one or all of the following characteristics are noticed on a fish: the stomach protrudes from the mouth, the eyes are bulging, the belly region is swollen, or the intestines are sticking out of the anus.
Circle Hooks The rules require fishers on all vessels fishing for reef fish in the Gulf to possess and use non-stainless steel circle hooks when natural baits are used. A circle hook is a fishing hook designed and manufactured so that the point is not offset, but turned perpendicularly back to the shank to form a generally circular or oval shape.
Dehooking Devices Fishers on all vessels fishing for reef fish in the Gulf and as of July 29, 2009, federal waters of the Atlantic, are required to possess and use a dehooking device to remove hooks embedded in reef fish with minimal damage. The dehooking device must be constructed to allow the hook to be secured and the barb shielded without re-engaging during the removal process. It must be blunt and all edges rounded, and it must be of a size appropriate to secure the range of hook sizes and styles used in the reef fish fishery. Venting Tools The new rules require fishers on all vessels fishing for reef fish in the Gulf to possess and use a venting tool to deflate the swimbladders of Gulf reef fish to help release the fish with minimum damage. This tool must be a sharpened, hollow instrument, such as a hypodermic syringe with the plunger removed or a 16-gauge needle fixed to a hollow wooden dowel. A tool such as a knife or an ice-pick may not be used.
The venting tool must be inserted into the fish at a 45-degree angle approximately 1 to 2 inches from the base of the pectoral fin and be inserted just deep enough to release the gases so that the fish may be released with minimum damage.
|